MSI MS-7156 Instruction Manual

iMS-7174 (v1.X M-ATX Mainboard)

1-4MS-7174 M-ATX MainboardMainboard LayoutMS-7174 v1.x M-ATX MainboardPCI1PCI_ExpressPCI2PCI3SYS_FAN1ATX_INVIAALC880VT6307ATX1DIMM2DIMM1JLPC1IDE1FDD1B

2-1Hardware SetupChapter 2. HardwareSetupThis chapter tells you how to install the CPU, memory modules,and expansion cards, as well as how to setup th

2-2 MS-7174 M-ATX MainboardPCI1PCI_ExpressPCI2PCI3SYS_FAN1ATX_INVIAALC880VT6307ATX1DIMM2DIMM1JLPC1IDE1FDD1BIOSIntelJPWD1BATT+IntelCPU_FANJAUX1F_USB2 U

2-3Hardware SetupCentral Processing Unit: CPUThe mainboard supports Intel® Pentium 4 Prescott processor. The mainboarduses a CPU socket called LGA775.

2-4 MS-7174 M-ATX MainboardCPU & Cooler InstallationWhen you are installing the CPU, make sure the CPU has a cooler at-tached on the top to preven

2-5Hardware Setup5.The CPU has a plastic cap on it toprotect the contact from damage.Before you have installed the CPU,always cover it to protect the

2-6 MS-7174 M-ATX Mainboard12. Press down the load lever lightlyonto the load plate, and then securethe lever with the hook under reten-tion tab.11.Vi

2-7Hardware SetupMemoryThe mainboard provides two 240-pin unbuffered DDR266/DDR333/DDR400 DDRSDRAM, and supports the memory size up to 2GB without ECC

2-8 MS-7174 M-ATX MainboardInstalling DDR Modules1. The DDR DIMM has only one notch on the center of module. The module willonly fit in the right orie

2-9Hardware SetupPower SupplyThe mainboard supports ATX power supply for the power system. Beforeinserting the power supply connector, always make sur

iiManual Rev: 1.0Release Date: April. 2005FCC-B Radio Frequency Interference StatementThis equipment has been tested and found to comply with the limi

2-10 MS-7174 M-ATX MainboardThe back panel provides the following connectors:Back PanelMouse/Keyboard ConnectorThe mainboard provides a standard PS/2®

2-11Hardware SetupUSB ConnectorsThe mainboard provides an OHCI (Open Host Controller Interface) UniversalSerial Bus root for attaching USB devices suc

2-12 MS-7174 M-ATX MainboardMSI Reminds You...For the advanced functions of the audio codec, please refer to Chapter6: Introduction to Realtek ALC880

2-13Hardware SetupParallel Port Connector: LPT1The mainboard provides a 25-pin female centronic connector as LPT. A parallelport is a standard printe

2-14 MS-7174 M-ATX MainboardThe mainboard provides connectors to connect to FDD, IDE HDD, case, LAN,and USB Ports.Floppy Disk Drive Connector: FDD1The

2-15Hardware SetupHard Disk Connector: IDE1The mainboard has one 32-bit Ultra DMA 66/100 IDE controller integrated in theSourthBridge ICH6R/ICH6, whic

2-16 MS-7174 M-ATX MainboardSerial ATA Connectors controlled by Intel ICH6 SATA1~SATA2The Southbridge of this mainboard is ICH6 which supports two ser

2-17Hardware SetupFront Panel Connectors: JFP1The mainboard provides one front panel connector for electrical connection tothe front panel switches an

2-18 MS-7174 M-ATX MainboardFront USB Connectors: F_USB1/2 (USB5/6/7/8)The mainboard provides two standard USB 2.0 pin headers F_USB1. USB 2.0technolo

2-19Hardware SetupIEEE 1394 Connector: J1394_1 (Optional)The mainboard provides two 1394 pin headers that allow you to connectoptional IEEE 1394 port.

iiiCopyright NoticeThe material in this document is the intellectual property of MICRO-STARINTERNATIONAL. We take every care in the preparation of thi

2-20 MS-7174 M-ATX MainboardThe motherboard provides the following jumpers for you to set the computer’sfunction. This section will explain how to cha

2-21Hardware SetupSlotsPCI Express SlotsThe PCI Express slots, as a high-bandwidth, low pin count, serial, intercon-nect technology, support Intel hig

2-22 MS-7174 M-ATX MainboardPCI Interrupt Request RoutingThe IRQ, acronym of interrupt request line and pronounced I-R-Q, are hard-ware lines over whi

iv1. Always read the safety instructions carefully.2. Keep this User’s Manual for future reference.3. Keep this equipment away from humidity.4. Lay th

vCONTENTSFCC-B Radio Frequency Interference Statement...iiCopyright Notice...

vi Aux Line_In Connector: JAUX1...2-18 CD-In Connector: JCD1..

1-1Getting StartedChapter 1. GettingStartedThank you for choosing the MS-7174 v1.x Micro ATXmainboard. The mainboard is based on Intel® 910GE and Inte

1-2MS-7174 M-ATX MainboardMainboard SpecificationsCPU† Supports Intel® Pentium 4/ Celeron D Prescott LGA775 processors in LGA775package.† Supports 200

1-3Getting StartedOn-Board Peripherals† On-Board Peripherals include:- 1 floppy port supports 1 FDD with 360K, 720K, 1.2M, 1.44M and 2.88Mbytes- 2 SP