MSI P45 User Manual download pdf (Page 17)

En-9

English

Connectors, Jumpers, Slots

Floppy Disk Drive Connector: FDD1

This connector supports 360KB, 720KB, 1.2MB, 1.44MB or 2.88MB floppy disk drive.

Fan Power Connectors: CPUFAN1/ SYSFAN1/ SYSFAN2

The fan power connectors support system cooling fan with +12V. The CPU FAN supports

Smart FAN function. When connect the wire to the connectors, always take note that the

red wire is the positive and should be connected to the +12V, the black wire is Ground

and should be connected to GND. If the mainboard has a System Hardware Monitor

chipset on-board, you must use a specially designed fan with speed sensor to take

advantage of the fan control.

IDE connector: IDE1

This connector supports IDE hard disk drives, optical disk drives and other IDE devices.

Important

1.Please refer to the recommended CPU fans at processor’s official website or

consult the vendors for proper CPU cooling fan.

2.CPUFAN supports fan control. You can install Dual Core Center utility that

will automatically control the CPU fan speed according to the actual CPU

temperature.

3. Fan cooler set with 3 or 4 pins power connector are both available for CPUFAN.

Important

If you install two IDE devices on the same cable, you must configure the drives

separately to Master/ Slave mode by setting jumpers. Refer to IDE device’s docu-

mentation supplied by the vendors for jumper setting instructions.

SYS FAN1/2

SENSOR or NC

+12V

GND

CPUFAN1

SENSOR

+12V

GND

Control

PDF created with pdfFactory Pro trial version www.pdffactory.com

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 91 92

No comments

MSI P45 User Manual Page 17