Msi K8T Master2-FAR7 User Manual download pdf (Page 31)

2-15

Hardware Setup

The mainboard provides connectors to connect to FDD, IDE HDD, case, LAN, USB

Ports, CPU/system power supply fans, ... and etc.

Floppy Disk Drive Connector: FDD1

The mainboard provides a standard floppy disk drive connector that supports 360K,

720K, 1.2M, 1.44M and 2.88M floppy disk types.

Connectors

MSI Reminds You...

If you install two hard disks on cable, you must configure the second

drive to Slave mode by setting its jumper. Refer to the hard disk docu-

mentation supplied by hard disk vendors for jumper setting instructions.

IDE1 (Primary IDE Connector)

The first hard drive should always be connected to IDE1. IDE1 can connect a

Master and a Slave drive. You must configure second hard drive to Slave

mode by setting the jumper accordingly.

IDE2 (Secondary IDE Connector)

IDE2 can also connect a Master and a Slave drive.

Hard Disk Connectors: IDE1, IDE2

The mainboard provides a 32-bit Enhanced PCI IDE and Ultra DMA 33/66/100/133

controller that supports PIO mode 0 ~ 4, Bus Master, and Ultra DMA 33/66/100/133

function. You can connect up to four hard disk drives, CD-ROM drives, 120MB floppy

disk drive (reserved for future BIOS), and other devices.

FDD1

IDE1

IDE2

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 96 97

No comments

Msi K8T Master2-FAR7 User Manual Page 31