Msi K8T Master2-FAR7 User Manual download pdf (Page 52)

3-12

MS-9617 ATX Workstation Board

MTRR Mapping Mode

This setting controls the MTRR mapping mode. To install the WinXP64, this

setting should be set to [Continuous]. Setting options: [Continuous], [Discrete].

DRAM ECC Feature Control

If all memory in the system supports ECC, enabling this will initial scrub dram and

enable system requests to dram to be checked and/or corrected. Options:

[Enabled], [Disabled].

ECC MCE Enable

This setting enables/disables the ECC MCE function. Options: [Enabled],

[Disabled].

Chip-Kill Mode Enable

This item allows you to enable/disable Chip-Kill ECC on Nodes with all x4 ECC

capable dimms. Options: [Enabled], [Disabled].

ECC Redirection

Enable Scrubber to correct errors detected in DRAM during normal CPU re-

quests (foreground scrubbing). Options: [Enabled], [Disabled].

LDT & PCI Bus Control

Press <Enter> and the following sub-menu appears:

Upstream / Downstream LDT Bus Width

These two item control the utilized widths of the HyperTransport link. Setting

options: [8 bit], [16 bit].

LDT Bus Frequency

This item specifies the maximum operating frequency of the link's transmitter

clock. Setting options: [Auto], [800 MHz], [600 MHz], [400 MHz], [200 MHz].

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 96 97

No comments

Msi K8T Master2-FAR7 User Manual Page 52