MSI K9N NEO V3 Datasheet download pdf (Page 44)

3-11

BIOS Setup

On-Chip IDE Controller

This item allows you to enable/ disable the IDE controller.

PCI IDE BusMaster

This item allows you to enable/ disable BIOS to used PCI busmastering for

reading/ writing to IDE drives.

On-Chip SATA Controller

This item allows you to enable/ disable the SATA controller.

RAID mode

Select [RAID] will enable RAID function. Select [AHCI] to enable the AHCI (Advanced

Host Contoller Interface) function. Select [IDE] to configure the SATA device as

IDE device and without AHCI fucntion.

I/O Devices

Press <Enter> to enter the sub-menu and the following screen appears:

COM Port 1

Select an address and corresponding interrupt for the first serial port.

Parallel Port

There is a built-in parallel port on the on-board Super I/O chipset that provides

Standard, ECP, and EPP features. It has the following options:

[Disabled]

[3BC/IRQ7] Line Printer port 0

[278/IRQ5] Line Printer port 2

[378/IRQ7] Line Printer port 1

Parallel Port Mode

[Normal] Stardand Parallel Port

[EPP] Enhanced Parallel Port

[ECP] Extended Capability Port

[Bi-Directional]Extended Capability Port + Enhanced Parallel Port

To operate the onboard parallel port as Standard Parallel Port only, choose

[Normal]. To operate the onboard parallel port in the EPP mode simultaneously,

choose [EPP]. By choosing [ECP], the onboard parallel port will operate in ECP

mode only. Choosing [Bi-Direction] will allow the onboard parallel port to support

both the ECP and EPP modes simultaneously.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 116 117

No comments

MSI K9N NEO V3 Datasheet Page 44