MSI K9N Neo V3 Series User Manual download pdf (Page 21)

2-7

Hardware Setup

Installing Memory Modules

1. The memory module has only one notch on the center and will only fit in the right

orientation.

2. Insert the memory module vertically into the DIMM slot. Then push it in until the

golden finger on the memory module is deeply inserted in the DIMM slot.

3. The plastic clip at each side of the DIMM slot will automatically close.

Important

You can barely see the golden finger if the memory module is properly inserted

in the DIMM slot.

Volt

Notch

Important

-DDR2 memory modules are not interchangeable with DDR and the DDR2

standard is not backwards compatible. You should always install DDR2

memory modules in the DDR2 DIMM slots.

-In Dual-Channel mode, make sure that you install memory modules of the

same type and density in different channel DIMM slots.

-To enable successful system boot-up, always insert the memory modules

into the DIMM1 first.

- Due to the chipset resource deployment, the system density will only be

detected up to 7+GB (not full 8GB) when each DIMM is installed with a 2GB

memory module.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 116 117

No comments

MSI K9N Neo V3 Series User Manual Page 21