Msi X2-109 v1 User Manual download pdf (Page 56)

4-4 MegaCLI Command Tool

You can specify the -Silent command line option for all possible

functions of the MegaCLI CT. If you enter this option at the command

line, no messages are displayed on the screen.

Some MegaCLI CT commands that are supported in hardware RAID

configurations are not supported under Embedded MegaRAID Software.

These include the following:

• Adapter Cache Flush (-AdpCacheFlush)

• Set Adapter Properties: Only the RebuildRate, BgiRate, CCRate,

and CoercionMode properties are supported

• Get Adapter Properties: Only the RebuildRate, BgiRate, CCRate,

and CoercionMode properties are supported

• Cluster Enable is not supported

• Set Adapter Time (-AdpSetTime)

• Patrol Read (-AdpPR, -AdpPRSetDelay)

• Battery Backup commands (-AdpBbuCmd)

• Foreign configuration (-CfgForeign)

• Logical Drive Reconstruction (-LDRecon)

• Set Logical Drive Properties (-LDSetProp)

• Display Enclosure Information (-EncInfo)

• Mark Configured Physical Disk Drive as Missing (-PDMarkMissing)

• Display List of Missing Physical Disk Drives (-PDGetMissing)

• Flashing the firmware (-AdpFWFlash, -AdpM0Flash)

• Diagnostics (-AdpDiag, -AdpBatTest, -AdpNVRAM)

The following sections describe the MegaCLI CT commands.

Note

: The Embedded MegaRAID Software utility does not

support Write Policy, Read Policy, or I/O Policy. Software

RAID only support enabling and disabling the hard disk

drive’s write cache and read-ahead functions.

Note

: MegaCLI CT for Embedded MegaRAID Software does not

support the concept of disk enclosures, except for a default

Enclosure 0 (E0). Some of the commands support an

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 131 132

No comments

Msi X2-109 v1 User Manual Page 56