Msi X2-109 v1 User Manual download pdf (Page 57)

Adapter Commands 4-5

E0:Sn syntax that enables you to specify a disk drive in a

particular “slot” in this default enclosure.

4.4 Adapter Commands

You can use the commands in this section to set or display properties

related to the adapter(s).

Note

: The Embedded MegaRAID Software drivers function as

virtual “adapters” or “controllers.” Because the drivers are

not actual hardware components, some of the adapter

parameters do not apply to them.

4.4.1 Display Adapter Information

Use the command in Table 4 . 2 to display information on adapter

parameters such as the number of logical drives and initiator ID.

4.4.2 Enable or Disable Automatic Rebuild

Use the command in Ta ble 4 . 3 to turn automatic rebuild on or off for the

selected adapter(s). If you have configured hotspares and enabled

automatic rebuild, the RAID adapter automatically tries to use them to

rebuild failed disks. Automatic rebuild also controls whether a rebuild will

start when a drive that was part of the array is reinserted.

Table 4.2 Display Adapter Information

Syntax CmdTool –AdpAllInfo -aN|-a0,1,2|-aALL

Description Displays parameters on the selected adapter(s). Displayed information includes

initiator ID, current status of auto rebuild, alarm, number of logical drives, rebuild

rate, bus number/device number, present RAM, SAS settings, serial number of the

board, and SAS address.

MegaCLI CT does not support display of the firmware version or BIOS version, as

the driver does not support it.

Table 4.3 Enable or Disable Automatic Rebuild

Syntax CmdTool –AdpAutoRbld -Enbl|-Dsbl|-Dsply -aN|-a0,1,2|-aALL

Description Enables or disables automatic rebuild on the selected adapter(s).

The -Dsply option shows the status of the automatic rebuild state.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 131 132

No comments

Msi X2-109 v1 User Manual Page 57