Msi X2-109 v1 User Manual download pdf (Page 70)

4-18 MegaCLI Command Tool

4.9.3 Set Physical Disk Drive State to Offline

Use the command in Ta b l e 4 . 2 9 to set the state of a physical disk drive

to Offline. In the offline state, the logical drive is not available to the

adapter.

4.9.4 Set Physical Disk Drive State to Unconfigured-Good

Use the command in Ta b l e 4 . 3 0 to set the state of a physical disk drive

from Unconfigured-Bad to Unconfigured-Good.

4.9.5 Manage Global Hotspares

Use the command in Table 4 . 3 1 to manage the configuration and

assignment of global hotspares

. Make sure the capacity of the hotspare

drive is equal to or larger than the capacity of the disks in the array and

that it is the same type of drive (SAS or SATA).

Note

: The hotspare drive will rebuild a failed drive even if it is

SAS and the array drives are SATA, or vice versa. Once

the rebuild is completed, LSI recommends that you replace

the new array member with a drive of the same type.

4.9.6 Rebuild Physical Disk Drive

Use the command in Table 4 . 3 2 to start or stop a rebuild on a physical

disk drive and display the rebuild progress. When a physical disk in an

Table 4.29 Set Physical Disk Drive State to Offline

Syntax CmdTool –PDOffline -PhysDrv[E0:S....] -aN|-a0,1,2|-aALL

Description Changes the physical disk drive state to Offline.

Table 4.30 Set Physical Disk Drive State to Unconfigured-Good

Syntax CmdTool –PDMakeGood -PhysDrv[E0:Sn...] -aN|-a0,1,2|-aALL

Description Changes the physical disk drive state from Unconfigured-Bad to Unconfigured-Good.

Table 4.31 Manage Hotspares

Syntax CmdTool –PDHSP {–Set} -Rmv -PhysDrv[E0:Sn....] -aN|-a0,1,2|-aALL

Description • -Set: Changes the physical disk drive state to hotspare for the enclosure.

• -Rmv: Changes the physical drive state to ready (removes the hotspare).

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 131 132

No comments

Msi X2-109 v1 User Manual Page 70